Audi Q7 not start

[chiptuner123]

Hi I need help with Audi Q7 the steering lock not Unlock the key turn,but dash not come up (not open) no starter and car not start


Is the elv problem??

ELV with 1L59W

HW- 4FO 905 852 B
SW - 4FO 910 852

I have the below error dtc.

Establishment diagnostic session with selected unit ....
Diagnostic channel is open.

Device identification:
VAG Number SW: 4F0910852 0220
4F0910131A 0080
VAG Number HW: 4F0909131A
System description: FBSAUDIC6 ELV H31
FBSAUDIC6 EZS H45
Workshop (Part/Imp/Supp): 83828/0207/03090
Date of production: 02.05.06
Vehicle information:
Coding: 131
I
Serial number: 10601000431831
FAZIT identification:
FAZIT Identification: MDW-RTH 02.05.06 2503 0457
Flash information:
Programming APPLICATION attempts: 1
Programming APPLICATION successfull: 1
Flasher info: 02.03.07 83828/0207/134162
Flash status: OK
Reflash preconditions: Waiting time not expired, Transmission RPM is not null

============================================
00166 Access/start authorization switch -E415
Status : Permanent error
defect
Priority : 1
* Error with strong effect! Immediate stop!
Frequency of the error : 6
Status of the error-counter : 87
Status of odometer : 409415 km
Date : 27.10.2006
Priority : 14:8:42
============================================
01176 Key
Status : Permanent error
missing signal / communication
Priority : 2
* Immediate need from workshop visit!
Frequency of the error : 4
Status of the error-counter : 87
Status of odometer : 409415 km
Date : 27.10.2006
Priority : 14:8:43
============================================

[brobble]

With ELV problem you can erase dtc and car can start again. But E415 is the ignition switch I think, where you put the key in. Buy a used from ebay for some bugs and test! :-)

Good luck.

Greetings MR...

[brobble]

This is E415:

[chiptuner123]

The used EZS need to adapt or play direct?The key where is stored? In EZS or in ELV??

[koyot]

ezs....................

[chiptuner123]

Can I program used ezs?

[immokill]

NEED SAME INFO BRO

[brobble]

The ignition switch E415 does‘nt need to be programmed. Just plug &play. But before changing I would check power supply and wiring.

Greets MR...

[brobble]

The keys are stored in ELV. The ELV („Elektronische Lenksäulen Verriegelung“, Elektronic Steering Lock) is the immobilzer in these cars. Some tells this EZS. EZS is „Elektronischer Zündanlass Schalter“ in german. Electronic Ignition Switch in english. This would be E415 in Q7, but in Q7 this is only switch with reading coil and magnet to hold the key. So it does not need to be learnt. It‘s no intelligent part... :-)

Greets MR...

[chiptuner123]

do you know how many ignition +12V MUST i HAVE IN MODULE e415??

[brobble]

When I‘m in my garage and I dont forget I will take a look into shematic diagram.

Greets MR...

[chiptuner123]

do you know if my problem is the ELV .I put the key in and not unlock and dash not light open,,,,,,

[chiptuner123]

in ignition sqitch I have two +12v .one in plug with 2 wire big , and one in plug with 6 wire smal

[chiptuner123]

Here is the reading with R270 flash + eeprom to check if any one know if are correct or coroopted

[brobble]

You have permanent 12V on T2a/1 and T6a/1, both red/blue. Both cables get this power from SB10 (ST1, red). Fuse box driver side (left side steering). 30A. Then you have a lot of connection direct from E415 to ELV. I dont believe, that the ELV is the problem. Either wiring or E415 it self. Just buy a used or new and try. I dont know, whether I may post the complete wiring diagram here in forum. If you need it: PM me...

Greets MR...

[ciekawy]

WAUZZZ4L27D020692
CS1-6 : 28AE4C5A515C
CS7-12 : BE34D30F7C69
MAC : 310F3915
PIN : 29820