Tawe
22nd September, 2017, 04:46 PM
Hi. I have problem with 2001 VW Lupo 1.0 (AUC Engine Code).
When I start the car cold, its everything okey, car increases rpms a little and then works at approx 700rpm.
Problem is that after 5mins (very little warm up), if I press accelerator pedal and release it, car won't idle, but cuts off. It would idle only if I release pedal very very slowly, and then works at approx 640rpm.
So have very good power, but just won't keep idle when depressing acc pedal.
Things I've already replaced:
- sparks
- plugs
- coil pack
- engine ecu
- coolant temp. sensor
- map sensor
- pre-cat lambda sensor/sonda
- throttle body (also alignment procedure with both vcds and autocom)
- egr valve is closed
There are no fault codes, just one time was showed:
- 16556/P0172 - System Too Rich, Bank 1
In VCDS, group 33, first field value for Additive at idle is ~25%
When I start the car cold, its everything okey, car increases rpms a little and then works at approx 700rpm.
Problem is that after 5mins (very little warm up), if I press accelerator pedal and release it, car won't idle, but cuts off. It would idle only if I release pedal very very slowly, and then works at approx 640rpm.
So have very good power, but just won't keep idle when depressing acc pedal.
Things I've already replaced:
- sparks
- plugs
- coil pack
- engine ecu
- coolant temp. sensor
- map sensor
- pre-cat lambda sensor/sonda
- throttle body (also alignment procedure with both vcds and autocom)
- egr valve is closed
There are no fault codes, just one time was showed:
- 16556/P0172 - System Too Rich, Bank 1
In VCDS, group 33, first field value for Additive at idle is ~25%