filetester
8th October, 2017, 02:59 PM
Hi DK Members,
as I posted in a previous thread I have problems to make a 986 Boxster run with water damaged M534 Alarm unit.
I got now another used unit with 2 key fobs.
So, when I attach M534 to the car these 2 key fobs should work when I press the remote buttons, right?
But nothing happens :-(
PST2 Tester gives me error codes "ECU fault" "Transponder not match with unit (reprogram key)" and so on.
But the unit and the key fobs are 100% from the same (accident) car with destroyed passenger side.
When I got unit, the 15A fuse was blown, but I put new one inside
I managed now to read the 93LC66A inside the unit and attach dump here.
Is the dump good or corrupt?
Is it possible to read the codes of the remote controls (2 pieces) out of this dump?
Can somebody read me the Immobilizer and the Pin Code out of this dump?
Thanks in advance and wish you a nice sunday!!!
as I posted in a previous thread I have problems to make a 986 Boxster run with water damaged M534 Alarm unit.
I got now another used unit with 2 key fobs.
So, when I attach M534 to the car these 2 key fobs should work when I press the remote buttons, right?
But nothing happens :-(
PST2 Tester gives me error codes "ECU fault" "Transponder not match with unit (reprogram key)" and so on.
But the unit and the key fobs are 100% from the same (accident) car with destroyed passenger side.
When I got unit, the 15A fuse was blown, but I put new one inside
I managed now to read the 93LC66A inside the unit and attach dump here.
Is the dump good or corrupt?
Is it possible to read the codes of the remote controls (2 pieces) out of this dump?
Can somebody read me the Immobilizer and the Pin Code out of this dump?
Thanks in advance and wish you a nice sunday!!!