Clio 1.4 16V Sirius 34 immo off.

[razor1199]

Hello,
friend ask me to remove immo from this car. He send me numbers, it's Sirius 34 S118301109A, probably it's with CAN so I guess I need an emulator, right?
Second problem is unfortunately I can't desolder this 29F400 (or 200). Is there any possibility to read it using KTAG? MPPS v16? Galletto v54?
I prefer KTAG (cause didn't yet reworked galletto).

Regards!

[brend]

Hello,
friend ask me to remove immo from this car. He send me numbers, it's Sirius 34 S118301109A, probably it's with CAN so I guess I need an emulator, right?
Second problem is unfortunately I can't desolder this 29F400 (or 200). Is there any possibility to read it using KTAG? MPPS v16? Galletto v54?
I prefer KTAG (cause didn't yet reworked galletto).

Regards!

Look at this all tool manual and you see do or not.Ktag no.Maybe Galletto v45.

[razor1199]

Okay.
What about solution? I think about emulator but if it is not needed then i won' have to but him.

[brend]

Okay.
What about solution? I think about emulator but if it is not needed then i won' have to but him.

What ebaut sulutions,put damp in dk and you see ,have eny DK members for this sulution or not.If not, next step only emulator.Thats all a think.:)And me,i dont have sulution for this.Good luck :)

[razor1199]

I will put dump as fast as I obtain this ECU :)

[razor1199]

I have found something about reading it. Just please tell me if my thinking is good. I haven't been using v54 yet.

For boot mode just put grey wire on pin 28 (Just like I painted it) and that is all or I need also put there any ground? Just paint the good version for me if I think bad. Is also additional +12v needed? Or galletto will send it itself?

http://i.imgur.com/UDXH0Umh.jpg (https://imgur.com/UDXH0Um)

[electronistul21]

for boot put black (GND) to pin 28,wihtout resistor.Remove suply,put boot wire,aply suply ,after 3-4 sec remove boot wire (you have mesage for this to desktop).