Advices resetting counters to zero on Peugeot

[nicolas2015]

As it says the title, i need some advices with this problem. The car : Peugeot 3008 1.6 hdi 2009, showing Fap additive level low, after the bag inside additive fluid tank exploded, i changed the bag with a brand new one, Eolys 176, tried to erase error P1446, no joy. I’ve been searching on interenet, apparently you need Pp2000 to reset the counter to zero. I’ve searched and purchased a new lexia 3 , updated to 7.83, looked to all videos on how to do it, after searching and looking went and tryed to reset the counters. NO JOY! With the 7.83 version on pp2000 doesnt show nothing , Engine Ecu not even comunicating, tryed with diagbox, went through all the steps, repair, etc, confuguration. When i’m trying to communicate with diesel additive Ecu - no communication. I’ve searched again, and decided to re-instal diagbox on a different laptop and i updated only up to 7.06, and again re-started the process. I need some advices please, the car is out of the road for 2 weeks, maybe it’s the Lexia, or Ecu , or maybe i’m not following the right procedure. Many thanks!

[WinWoj]

if you have lexia, very good. Diagbox do this job perfectly, but communication with diesel addituve ecu is very important. if you have communication with all ecu's but additive not, you have to measure voltage, good ground, and continuity between engine ecu and additive ecu. Because the procedure is resetting both modules, and your tutorial should give you proper way. just repair electrical problem in additive ecu, then procedure shoud be done. or - read ecu flash and delete Dtc's, but never sure if it's will be working. regards

[nicolas2015]

Many thanks!