PDA

View Full Version : 5P08C3



erikfrog
21st October, 2009, 10:07 PM
Hi it?s possible to read and write 5P08C3 memory with Willem programmer?
If yes, how?
Thanks

jokersat
21st October, 2009, 10:59 PM
your willem is PCB 3 or 4.5 or 5 or ........

erikfrog
22nd October, 2009, 07:21 AM
Hard to say, its Willem PRO 4 ISP from Poland should be compatible with sw 098D8

digi-tech
26th October, 2009, 11:55 PM
no it is not

phatty123
27th October, 2009, 02:16 AM
what about with a smartpro x5?

Bravestarr
24th June, 2010, 11:15 PM
Hi it?s possible to read and write 5P08C3 memory with Willem programmer?
If yes, how?
Thanks

Any news? Can i prog this type with willem pcb 5?
(whitch type is compatible with 5P08C3 = 24cxxx ??? or ...)

PremierD
25th June, 2010, 07:43 AM
Any news? Can i prog this type with willem pcb 5?
(whitch type is compatible with 5P08C3 = 24cxxx ??? or ...)

Its a 95p08 mate ..........spi eeprom ...

Bravestarr
25th June, 2010, 11:49 AM
Its a 95p08 mate ..........spi eeprom ...


thanks!!
5P08C3 = ST95P08 => not supported by willem 5.

damih
26th June, 2010, 06:17 PM
Hello,you can't read a 5P08C3 with a willem

carsolution
27th June, 2010, 01:01 AM
Hi friend.
No need to spend a lot in programmers.
I have an expensive one that is Beeprog+ but I also have a Batronix Bagero BX40 and it is really good and I spent just 230€.
If you wnat still doing this kind of jobs you must buy a good programmer or else you are going to spend more money buying specific tools.
For this kind of job you need brains and good programmer.
For me at this moment just need upa and BX40, Beeprog I just use it for specific processors I find in Robotics, for MCU and car eproms BX40 and UPA are good.
Best Regards to all members.
Regards,
Nuno

marcus5
27th June, 2010, 01:31 AM
Read and written 5P08C3 with willem programmer and PSOP Adapter SOIC8 .....