filutek
22nd October, 2017, 03:59 PM
Hello,
I want to replace an ignition (with 2 HC08AZ48A 1L02M Motorola MCUs). I read the old ignition with SMOG JTAG ETL but I could only read the EEPROM (Flash wasn't listed with this mask). I just copied the EEPROM from the old to the new one (just because I could only read them) the car starts, ABS ESP controls light and there is an EZS configuration error in the ABS module. There is a connectivity issue in Star Diagnosis with the EZS module after copying the EEPROM contents. VIN isn't read properly by the Star Diagnosis (it is read as some strange characters). What programmer device should I use to properly read and copy FLASH in this mask?
I want to replace an ignition (with 2 HC08AZ48A 1L02M Motorola MCUs). I read the old ignition with SMOG JTAG ETL but I could only read the EEPROM (Flash wasn't listed with this mask). I just copied the EEPROM from the old to the new one (just because I could only read them) the car starts, ABS ESP controls light and there is an EZS configuration error in the ABS module. There is a connectivity issue in Star Diagnosis with the EZS module after copying the EEPROM contents. VIN isn't read properly by the Star Diagnosis (it is read as some strange characters). What programmer device should I use to properly read and copy FLASH in this mask?