jifjaf1c
31st October, 2017, 10:02 PM
hi
have a problem with a Kyron 2l ecu a6645408432 dcm3.2 20dt e4
am still stuck after putting the reprogrammed eerom back in, the vehicle starts and idles at 1200rpm it will not rev up and returns fault codes. when we first put ecu in I've cleared all fault codes bar 1 which keeps returning due to the glow plug controller to be sure its not affecting the k line I've tried uncoupling the controller but no difference. is there anything I've overlooked
also is it possible to extract the immo pin code from the eeprom can prog a new key but it asks for immo pin code, also as a thought is there anyway of putting a known transponder key into the eeprom
any help would be much much appreciated files attached
phil
have a problem with a Kyron 2l ecu a6645408432 dcm3.2 20dt e4
am still stuck after putting the reprogrammed eerom back in, the vehicle starts and idles at 1200rpm it will not rev up and returns fault codes. when we first put ecu in I've cleared all fault codes bar 1 which keeps returning due to the glow plug controller to be sure its not affecting the k line I've tried uncoupling the controller but no difference. is there anything I've overlooked
also is it possible to extract the immo pin code from the eeprom can prog a new key but it asks for immo pin code, also as a thought is there anyway of putting a known transponder key into the eeprom
any help would be much much appreciated files attached
phil