Passat B6 steering lock problem HELP

[Fliper85]

I have a problem ... I bought a new blockade steering wheel and I wanted to do it ... I have a PIN ... Unfortunately by accident on the new lock I switched on 3x ignition and lock blocked .. or now have to buy a new lock? please help

[rafal]

Make sure a battery charger is connected so the voltage is maintained.

[25-Immobilizer]
[Adaption - 10]
Leave channel at "00"
[Read]
[Save]
[Done, Go Back]

[Security Access-16]
Enter the vehicle PIN in a 5 digit format.
[Do it!]
[Adaption - 10]
Read Channel 051.
The Stored Value will be 32000. Enter the PIN in the New Value box.
[Test]
Wait | N/A | N/A | N/A Will be displayed. Wait until the ID numbers are transferred into the first 2 boxes. If you aren't sure, be patient and wait at least 30 seconds!
[Save] (Note: if Save is not available and the data in the last step has transferred continue by exiting)
[Done, Go Back]

Check fault codes in all installed control modules and clear them as needed.

[Fliper85]

By entering the block 25-immobilizer gets a message from the pin is invalid :( in 01-ECU can log on the same pin ... what ideas ??

[vlaki electric]

see secuirity wait time in immobilizer
or send dump from comfort module to chek is your pin ok

[Fliper85]

see secuirity wait time in immobilizer
or send dump from comfort module to chek is your pin ok

Dump from comfort module ...

[Weasel3]

Did you solve this from another thread already?
PIN: 37560

[Fliper85]

Unfortunately not ... the comfort module or lock does not accept a PIN

[Weasel3]

The dumps opens fine.
Shows PIN, CS and VIN.
2 keys registered.

[Fliper85]

Works on VAS ... enters IMMO tries to insert PIN and nothing :( PIN is invalid ... to ECU logs in without problem

[simaservis1108]

Solution to your problem is here:

http://www.digital-kaos.co.uk/forums/showthread.php/485095-VW-Passat-B6-steering-lock?p=2963684&viewfull=1#post2963684

I was in the same situation and I solved it,so don't worry!

[Weasel3]

Maybe ODIS online can adapt.
Could you ask local dealer for support, in your country.
Or head office importer support, in your country.

[Cr4nky]

Do you have old lock? If so plug that in first, log in, swap plug to new one and it will work.

[Fliper85]

The old steering lock is defective :(

[Fliper85]

Sorry, we still do not accept the PIN ....

[simaservis1108]

Carefully read what is written in the link I sent you and all will be OK...

[Fliper85]

Only problem is that I do not have an old lock :(

[Cr4nky]

You don't have old lock at all? Or just that it is broken? If you have it, swap chip from old to new, job done.