help immo off megane coupe dti 100

[ivanrojo]

hello coukd someone please help with immo off for that car, it is a megane dti 100 hp msa15. i have tried almost every thing and nothing works, even soldering pin 7 to 8.

best regards.

[brahimdyag10]

here you are looking good luck

[ivanrojo]

pass please¿? i have to use a new eeprom or solder pin 7 to 8?

[Shmortz]

the best is to make virgin and put emulator, with write protected eeprom ECU can't store or delete any DTC's, it will be very hard to repair that car in the future...

[ivanrojo]

how much cost and where can i buy a emultor?

[vladanr]

you can do it in immokiller ,and lift pin 7 and connect with pin 8 on eprom

[ivanrojo]

sorry but i donñt have immokiller, just volta and immo tolol 1.5, any of htem work ok even lifting pin 7 and soldering to 8.

COuld somone check if original eprom file is corrected read?

[ivanrojo]

I have just bought emulator for renault msa15 does someone has virgin file for that ecu, i have download immo killer, when i tried to make immo off it says file must to be 512b and mine (and all other arround internet) are 256.

Other question is can i solder emulator inside de ecu?

[vladanr]

is it 24c02 eprom, ecu with 1 plug

[ivanrojo]

yes it is 1 plug msa15

[Pyromaniak]

lift pin 7 solder to pin 8 and cut wire 59 to ecu

[aroo84]

Check your eeprom. If you have Fairchild, you don't have write protection, then solder of pins 7&8 don't work.

[ivanrojo]

i have bought emulator, has someone got a picture of how to conected on ecu? protected eeproms are 24lc02 ?

[ivanrojo]

immo killer tell me my file is too small must to be 512 and mine is 256, maybe there is problem!

[ivanrojo]

i have soldered a emulator, but it doesnt work.....




http://i66.tinypic.com/2h8722o.jpg

any idea i need help

[kiszka]

..........

[ivanrojo]

hi kiszka on my original file I hasn´t got those digits.

[ivanrojo]

hi kiszka on my original file I hasn´t got those digits.

3e-41 are adresses?

[kiszka]

..........

[ivanrojo]

ok i will try

[ivanrojo]

hi kizzka still problem, i try modifiying eprosm as you told me but it neather works

[Pyromaniak]

maybe is problem elsewhere, if you cranking, do you see rpm on diagnostic? if you have clip or ddt200 you need looking on immobiliser status in ecu parameters.

[Pyromaniak]

problem elsevhere? rpm senzor? Or interia fuel switch? Bad stop valve?