View Full Version : Bmw E39 520D 136hp
Ionutzllz
27th November, 2017, 12:45 PM
hy guys. i have stage 1 more hp to my bmw e39 520d 136hp 2002 but when i`m rolling uphill he enter in limp mode. in rheingold say turbo pressure to high ( calculated - 2.2 measured 2.4). everyone can help me to change map?
bobolin4o
27th November, 2017, 12:50 PM
Post original too!
Ignasvw
27th November, 2017, 01:39 PM
Try this. Use thanks and reputation
Ionutzllz
11th December, 2017, 12:53 PM
Ignasvw please checksum the map. the car not start
fzhut
11th December, 2017, 01:11 PM
Calculate cks with Your tool. I always calculate it with Kess. WinOLS 2.24 does not calculate it.
Ionutzllz
11th December, 2017, 01:15 PM
my kess say use protocol 50
maajkii
11th December, 2017, 01:22 PM
my kess say use protocol 50
here you go
Ionutzllz
11th December, 2017, 01:26 PM
i read with mpps. now i push checksum and write but car not start
Ionutzllz
11th December, 2017, 01:30 PM
maajkii now is start. thank you verry much
Ionutzllz
11th December, 2017, 05:35 PM
I tested and now is ok. Not entering in limp mode. Thank you
SpecZ
11th December, 2017, 06:40 PM
I tested and now is ok. Not entering in limp mode. Thank you
If you want to remove the 207-211 km/h speed limiter open map 0414C and fill it with 10000 or change the 20700 and the 21100 values directly on axis! ;)
maajkii
11th December, 2017, 06:56 PM
maajkii now is start. thank you verry much
im happy too.
there are two magic buttons, pls push it.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.