ME7.1.1 dead after programming

[Inquizit0r]

Hi mates!
ME7.1.1 dead after programming via OBD. As i know ECU locked.
Please patch my 95160 eeprom.
THNX.

P.S. THNX+REP will be added.

[maajkii]

try flash ecu again!!
i have same situation!
its flashed after 2-3times and works fine!

[spychu14]

Use Kess and recovery option. It will work. I bet you have fault about not ended programming.

[rob h]

mpps, if all fails

[voltechcar]

device have problem with this ecu to calc crc. You must write this file kess, dont calc crc with winols or other programs before this operatios, becuase kess calc crc bad and car not start.

[Inquizit0r]

Anybody have full for 07K 906 032 Q VW Jetta 2.5?

[Inquizit0r]

ECU cant accept any any error read request. Only show physical ECU number. Write external flash via KTAG - nothing. No check engine light. MPPS can't write - ECU Number not identifyed. Kess cant write too...

[voltechcar]

Man I write solution, Kess writing this ecu to any problem, i do this operation several times

[dtip]

device have problem with this ecu to calc crc. You must write this file kess, dont calc crc with winols or other programs before this operatios, becuase kess calc crc bad and car not start.

You say kess calculate crc wrong with this ecu, and then you say "dont calc crc with winols" .... how crc will be good then ?

[johak]

only kess has to calculate checksum not winols

[Inquizit0r]

Guys, problem solved. I'm write eeprom from other ecu and etc. ECU is live again :)
Something corrupt eeprom while flash was written. I'm use external power... Strange.
KESS, MPPS, Galetto do not connect to ECU in this state. I'm using KTAG, write flash, then write pathced eeprom. All ok.

[voltechcar]

where I write " kess calculated wrong crc " ?

[dtip]

where I write " kess calculated wrong crc " ?

you wrote quoting - "device have problem with this ecu to calc crc" or you maybe mean other devices...

[voltechcar]

you have problem to read and understand. Read all my statement and than understand.

[dtip]

device have problem with this ecu to calc crc. You must write this file kess, dont calc crc with winols or other programs before this operatios, becuase kess calc crc bad and car not start.


where I write " kess calculated wrong crc " ?


you have problem to read and understand. Read all my statement and than understand.


Yes i do have problem understanding what you mean, look what you wrote...

[voltechcar]

ha ha ha ha ha ha, horse understand but you not.

[dtip]

ha ha ha ha ha ha, horse understand but you not.

No need to be rude, i guess you made typing mistake so i asked, sorry it upset you. All best

[Novik_UA]

When you make CS with WinOls, and than try to write with Kess - it will recalculate CS and will be bad calculated, and when you give file without calculated CS , it make it good.

[tech_cz]

Try:

WBR, Marek

[Paranoiak]

becarefull for ecu petrol audi voltage13V stable required