Kia Sportage 2017 crash clear

[AUTODIAGNOZA]

Hi!
I need to clear crash on this unit.
95910-F1000
Infineon X2361A-72F
With crash dump i get just frontal crash error, but when i clear the dump, i get "internal error - replace SRS ecu".
When i write tested working dump from another car, i get the same internal fault error and the ABS, ESP, Traction Control and Auto Hold lights came up and i need to recalibrate the longitudinal acceleration sensor. The error remains even if i write original dump into srs ecu.
I can't recalibrate the sensor due the year of the car. No scanner can do this, maybe GDS. I will try to install GDS.
I want to try again with another clear type, if someone can help me.
Thanks!

[dragon100]

Ok, what did you use for clear crash ?

[AUTODIAGNOZA]

Someone from this forum helped me.

[dragon100]

Your cleared file, pass in pm, clear errors, switch ignition off for 10 sec, switch ignition on, clear errors again and report ...

[AUTODIAGNOZA]

Now i have no errors, but light is on.

[dragon100]

Ok, I will check and compare again with good tested file ...Did you do clear procedure ?

[AUTODIAGNOZA]

I looked in live data and i saw that the pretensioner for passenger is open circuit and i simulate with a resistor.
The light went out for now. Do you think is ok? The scanner didn’t show any error

[dragon100]

100% ok, sometimes pretensioners do like this, no errors but light on, always after crash must replace or join resistor for check and clear errors. Good job ...

[AUTODIAGNOZA]

Good job, Dragon! Thank you very much.

[dragon100]

Could you share photo sticker this srs unit ?

[AUTODIAGNOZA]

...............Yes