PDA

View Full Version : Peugeot SID208 speedlimiter question



Ignasvw
12th December, 2017, 01:38 PM
Hi, i have peugeot boxer 3 2016yrs. 2.2 engine. Cmd gave me id for sid208. I read this via obd. Now i have this file and i need to raise speedlimiter, Now its set to 110-115. Tried to find in file, but i have too much options for it. Maybe someone done this job on this ecu? On ford i now its 4x speedlimiter in file. but how on this ecu? Regards. I attach ori file. And maybe i need full bdm to do this?

icezero2010
13th December, 2017, 02:15 AM
never done this car but check adress 52d8

pike
13th December, 2017, 10:21 AM
Hi, auto without DPF?

maajkii
13th December, 2017, 10:49 AM
Hi, auto without DPF?

Its 2016y so im shure Its with DPF.
I try to do this with swiftec but No sucess


Wysłane z iPhone za pomocą Tapatalk

pike
13th December, 2017, 11:01 AM
Its 2016y so im shure Its with DPF.
I try to do this with swiftec but No sucess


Wysłane z iPhone za pomocą Tapatalk


It is quite possible that swiftec is not ready to accept this obd file.

maajkii
13th December, 2017, 11:02 AM
It is quite possible that swiftec is not ready to accept this obd file.

Maybe... i dont try this car never before..


Wysłane z iPhone za pomocą Tapatalk

Ignasvw
13th December, 2017, 11:02 AM
im sure this is with dpf. now i have full read with eeprom and irom. Tried to use peugeot diagnostic, but no luck. It has only older boxer version. Tried to connect like citroen, it found ecu, i choosed sid208, i opened ?set speed limiter? section. But then it gaves me communication error. In BSI speed limiter is deactivated. In past this car was used in car rent Firm. I attach eeproms and irom

raedareeg
1st December, 2018, 04:47 PM
have you found solution y
et?