Opel Corsa D BCM how to clone? delphi

[soxten]

Is it possible to clone this?
I can read eeprom and flash with Smoke by obd.
But only write Eeprom, not Flash.

Delphi
13279900


I have a used BCM with same number, does it work to write only Eeprom from broken to used?

https://uploads.tapatalk-cdn.com/20171213/97cd17c67213d2b21bd6d59e761f65df.jpg

https://uploads.tapatalk-cdn.com/20171213/6fb1cae02048276d037d521257f19d79.jpg

https://uploads.tapatalk-cdn.com/20171213/40650bb71369391db26329dd83508ca7.jpg

https://uploads.tapatalk-cdn.com/20171213/d8284fa9c4b600b7bffb36521ebe9bf3.jpg




Skickat från min iPhone med Tapatalk

[rob h]

What is wrong with the old one?
You could transfer the hole processor.

You could learn a key to the new bsi, and make ecu virgin to match.

[soxten]

I dont know the fault in broken.
I need to separate pcb to get mcu and that is hard...

Is "key" to decrypt eeprom in flash?

Do I need bothe flash and Eeprom to clone?


Skickat från min iPhone med Tapatalk

[norman1967]

Enter service mode read epprom from original and fit Donar enter service mode write epprom

Start car post results

[Bllinda]

Find both pin codes,
And place bcm and continue with tec2h

[exe123]

Does not work to write eeprom only. key for decryption is inside flash. Best way to reset unit and learn with Tech2/MDI

[Bllinda]

If bcm was used, pinx2 will be required

[rob h]

How can these be reset?

[purdy]

What wrong with bsi. Common to get corrupted with flat battery. Easy fix with tech2 (15mins pressing buttons) Just reset and program back in. There is also a SW update that fixes the problem.


Sent from my iPhone using Tapatalk

[Fec001]

Can someone give me connection diagram NEC 70F3238 for VVDI prog?

[Bllinda]

Only.upa-usb....

[Fec001]

Solved. Just connect like VVDI manual except FLMD1. FLMD0 to PDX

[Sasika]

Hi guys,
I have same problem. I tried to read the nec with vvdiprog and UPA but always got error message. UPA: RXD pin low. Vvdiprog same, can't read it.
I tried couple pinout.
Attached the pinouts and my original board.
I tried what @Fec001wrote but same: error.
What is the trick for read the corsa D 2009 bcm dump?
777401
777402
777403

[rob h]

Using upa, stop on errors, off!
That works for me, on HFM.
It might help in this case.

And pay attention using orange5 connections, swap rxd txd.

Low baudrate, and try all mhz.

[Sasika]

I tried all mhz with all baudrate. Untick stopp on errors, swapped the rx-tx.
Device not respond, parameter error.
I will try read with io terminal.

[Masterprog]

HELLO friends can someone gives me a pinout to read this bcm on table
BEST REGARDS