Help change Vin In The Instrument Cluster

[easycome]

I had a task to replace cluster on AUDI A4 1.9 B6 2004
I read both pins, make login and go to adaptions channel 50, when i hit test it shows me System not OK.


[Select]
[17 - Instruments]

[Login - 11]
For the following procedure, use the PIN of the REPLACEMENT (NEW or USED) instrument cluster.
§ 4-digit PIN
§ Enter zero followed by the 4-digit PIN directly in the Login field. For example, if your PIN is 1234, enter 01234.
[Do it!]

[Adaptation - 10]
Enter 050 in "Channel Number".
[Read]
For the following procedure, use the PIN of the OLD (ORIGINAL) instrument cluster.
§ 4-digit PIN
§ Enter zero followed by the 4-digit PIN directly in the New Value field. For example, if your PIN is 1234, enter 01234.
[Test]
§ The values may change to "32000", this is normal
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]
§ Switch OFF the ignition and let the car sit for ~1 minute, then switch ON the ignition again.
§ Verify that the REPLACEMENT (NEW or USED) instrument cluster now shows the VIN/IMMO-ID of the vehicle now.


https://www.youtube.com/watch?v=-thKQjdckfs&feature=youtu.be

[antenor]

Why you dont swap the EEPROM??

[easycome]

It can cange from one board to another?





it can change from one board to another