hi mates, need advice maybe somebody had the same situation 2010 for explorer b2293

[Flomaster]

hi
2010 ford explorer, having problem with code b2293-00 restaint system: airbag fault try to disconnect everything and connected back still the same code dont know where to look, maybe someone had the same problem before ? also having crash and clean files, thanks in advance

[automotrizVIP]

HERE .....
https://www.stangnet.com/images/stories/docs/s197_TSBs/07-12-03.pdf
A Code 21 with a B2293 indicates a problem with the Restraint System — Air Bag Fault (Passenger Front Air Bag Circuit Fault)
The troubleshooting for this is long and involved... Or it could be as simple as you did not hook up the weight sensor on the passender side seat....


Here's just 1 part of the info for that code combination


Pinpoint Test K: LFC 19 and 21/DTC B2293 — Restraint System — Air Bag Fault
Normal Operation


The front air bags will deploy upon receiving a flow of current from the restraints control module (RCM). Refer to Air Bag and Safety Belt Pretensioner Supplemental Restraint System (SRS) in this section.
The RCM checks all of the front air bag circuits for faults. If the RCM detects one of the following faults on any of the front air bag circuits, it will store diagnostic trouble code (DTC) B2293 in memory, and depending on the fault, flash either lamp fault code (LFC) 19 or 21 depending on the fault (or higher priority code if one exists) on the air bag indicator.
Fault Conditions


The RCM monitors for the following fault conditions:


* Low resistance
* High resistance or circuit open
* Circuit short to voltage
* Circuit short to ground


Possible Causes


A passenger air bag fault can be caused by:


* damaged wiring, terminals or connectors.
* a faulty passenger air bag module.
* a faulted RCM.