Opel Insignia 2012 13588100

[pedjica]

Please help clear crush.Thanks

[dragon100]

Im not sure your file is good read, check again ... I upload crash for example from Insignia the same numbers ...

[pedjica]

reed upa s ... control unit GM 1358 8100 TB
(20T) AS8100T122360068

[dragon100]

Did you check my file with crash ?

[dragon100]

If you are sure your file work, check this clear ...

[pedjica]

Not the same size....
I read file again.

[dragon100]

I cleared your ori and size it same your ori ...

[pedjica]

Its done ...tnx

[dragon100]

Work ok ? ........................

[pedjica]

Yes work perfect... I use my dump and using your dump I clear... Start line 6C0-0B to 6D0 -06 FF is clear ok. Thanks again.

[pedjica]

Pinout opel insignia for all.
494631

[Isiantek]

Are You sure that this pinout is ok? I tryied read UPA-S and cant read

[fes_786]

here is pic that makes it clear


thanks

[sinvadol]

Good afternoon! I really need your help. After a long drawdown of the battery, opel insignia issues an error on the SRS block. There was no accident. No one can count the dump, they say the block is for replacement. I found a pinout on the forum. Where to solder the wires I understood, but what is at the other end? What software should I use to read the dump? Do you have a working dump. Block 1358 8100

[Julesd]

Hi,
I take it that is UPA pinout?

[fuzz1]

Hi,
I take it that is UPA pinout?

Hi
Why do you ask this question? Curiosity makes me ask why

[Julesd]

I am just programming a clear file to the same ECU.
I cannot get data flash to program. only emulated eeprom clear file.
Is that OK?
Thanks.

[sniegavirs]

Pinout opel insignia for all.
494631
The RESET pin is wrong!!! Reset pin is on the trace where "cut for read & write" is shown. And no need to cut anything!