milleage change on 2006 bmw e90 325i

[sideshow]

hi all I'm trying to figure out how to read the cas on a 2006 bmw 325i

plus also is it a cas2



ive tried with bmw tool but it says use cas plugs but the cas plugs with bmw tool are different to cas
as I think bmw is cas2 and bmw tool has cas 3 plugs

ive also tried with my digipro3 clone but I cant get a connection but I'm not sure if its my cable

can a clone digiprog 3 do the e90 cas thru obd2 and then I do the cluster manually


if not I also have the r270 cas programmer but I cant find what code the cas is so I can get the picture

any help is greatly appreciated

thanks

[brend]

Mate in picture not cas.I send for you cas location......................:)

[sideshow]

hi thanks for quick reply

I looked thru your pdf and the unit I removed looks the same as in the last page

I removed the module that's behind the bottom of glovebox and that sticker is only one on it

[brend]

hi thanks for quick reply

I looked thru your pdf and the unit I removed looks the same as in the last page

I removed the module that's behind the bottom of glovebox and that sticker is only one on it

its look like that.

[sideshow]

hi its same as the one in this pic but this pic is for left hand drive
mine is right hand drive

it has the black and the blue plug like this one

[brend]

hi its same as the one in this pic but this pic is for left hand drive
mine is right hand drive

it has the black and the blue plug like this one

Mate. You cas look only like that and cas color or black or white no more sulution thats all.So find this........................lol

[sideshow]

hi brend under the steering wheel area we do have something that looks like the white unit

thanks for all your help

[sideshow]

hi brend i removed that white unit under the steering wheel area and the cas plug from my
bmw tool does plug into it
but i still get an error saying cant find cas
what is best tool for doing these cas2

thanks

[brend]

Same high quality programmer for safe read by bdm like x-prog,blak box R260, USB UPA (very good tool for adjustment).

[sideshow]

hi i just pulled it apart and the cas2 is a 2k79x
so i ran the r270 software and i found the pic of how to wire that up

and it looks like abit of a fiddly job so i might wait for a long free day before i attempt to solder the wires from the r270 onto the board of the cas2

it has laquer on the board so ill have to get some solvent to clean it

is there any tool that will read cas without soldering onto the baord
i have digiprog3 clone bmw multi tool and r270 programmer

thanks for all your help