PDA

View Full Version : Bosch EDC16C39 popcorn limiter possible through OBD port?



walshy155
28th December, 2017, 12:00 AM
Hello guys, I've been told it's not possible to do hard cut popcorn limiter on a Bosch edc16c39? And also EGR off, 02 sensors off, can anybody tell me if it possible?

maajkii
28th December, 2017, 12:07 AM
Its possible but not with obd read. One map for popcorn is missed, Ofc it can be done on duration or torque. But best is svrl available in BDM read.
EGR off is possible, o2 sensors too.


Wysłane z iPhone za pomocą Tapatalk

mancioks
28th December, 2017, 07:00 AM
Hi, not 1CC83C for example in this file? This is OBD read.

maajkii
28th December, 2017, 10:23 AM
Hi, not 1CC83C for example in this file? This is OBD read.

BDM read for SVRL.


Wysłane z iPhone za pomocą Tapatalk

walshy155
28th December, 2017, 12:17 PM
Thank you very much maajkii

johak
28th December, 2017, 12:33 PM
in the sample file of mancioks 1CC83C is a revolution limiter

mancioks
28th December, 2017, 12:35 PM
in the sample file of mancioks 1CC83C is a revolution limiter
So it is correct or not?

johak
28th December, 2017, 12:42 PM
maybe it will work, try

walshy155
29th December, 2017, 12:39 PM
Hello people, I've put hard cut limiter on my car 1.9 16v mjet Bosch edc16c39, the method is injection quantity and I get fuel temperature to high fault code on the limiter, although fuel temperature is about 15 degrees, I'm guessing the only way around it is to use SVRL method?

mancioks
29th December, 2017, 12:47 PM
Did you tried change value that i wrote before? Also You can try torque limiter cut. Put Your files here it will be easier

maajkii
29th December, 2017, 01:30 PM
Hello people, I've put hard cut limiter on my car 1.9 16v mjet Bosch edc16c39, the method is injection quantity and I get fuel temperature to high fault code on the limiter, although fuel temperature is about 15 degrees, I'm guessing the only way around it is to use SVRL method?

cut torque limiter..

walshy155
31st December, 2017, 12:38 AM
Hello people can you check my map file to see if the map is any good, it is stage 1, EGR off, O2 off and hardcut limiter, the limiter produces fault code like I mentioned before if somebody could check it that would help a lot and Id be greatful