Ford Delphi dcm 3.5 FAP

[yeager]

Hi, i need turn off fap on fird, whit dcm 3.5 but my gal2 dont have obd read option for this car. I thinking about write to it flash from other car, is it this possible without damage ecu? Thx

[yeager]

Not possible read it obd?
Not possible write file from other car?

[gyapi11]

Hi. Kess read and write.

[yeager]

I dont have kess :(
Can i write whit gal2 file from other car read whit kess?

[maajkii]

so just read this ecu via BDM with fgtech... Fast and safety way :)

[yeager]

Not fast, i must disassemble car and ecu :(

[yeager]

i disassemble ecu, connect wire like in manual, but on read always get error ... hope i must read it like BDM/MPC55xx

[yeager]

in manual i have only for PSA is it same as ford? pins are same ...

[yeager]

exist a new bdm connection manual? i have only from year 2011, there is connected pin9 VDD, but in adapter on second site this pin is not connected, now im not sure, what to do ...

[yeager]

i think i use bad connection, have someone connection diagram like in video?
https://www.youtube.com/watch?v=A4amPdEh01w

[yeager]

ok, finally i found correct connection ... can someone make me good fap off? thx

[maajkii]

use kess, today done writing. no problems.

[yeager]

Now i can read/write ... Need correc file

[maajkii]

if you need swiftec solution let me know, not tested buy probably work.
p.s. post correct connection, maybe someone will need it in future.

[xCata]

Try these and report!
Pass pm.

[yeager]

Noone have tested solution? It is hard to disassemble again ...

[yeager]

Noone have tested solution? It is hard to disassemble and reprogram whenn will not work

[yeager]

working pinout for this ecu

[yeager]

Try these and report!
Pass pm.

up to line 20006F you rewrit all lines to FF FF FF Ff ... you realy think it will work? :)

ADS DPF solution is tested? it will work?

[Manny7861]

Hi mate have you got correct connection diagram