PDA

View Full Version : ME7.1.1 ST10 95160 EEPROM FIX after unsuccessful flashing



volter
31st December, 2017, 09:41 AM
Hi Everyone.
The car I'm struggling with is A3 3.2 2008 with DSG. I made a read with kess V2 through OBD modified software and tried upload it to the ecu, but something went wrong and Kess stucked at 50%.
After that the engine doesn't start, VCDS recognises just part number of the ECU, but It can't read Fault codes or measuring blocks.

I tried put original flash file in to ecu on the bench with K-Tag but it didn't help.

The last Idea is the ECU saved "incorrect flashing procedure state" in the eeprom, but I don't have enough knowledge to fix the content. Anybody of You fix it for me. please? Obviously I can pay for working solution.

Best REGARDS for You

You can download files from link below:
https://drive.google.com/open?id=1wo..._RTZwmEgO_ywqd (https://drive.google.com/open?id=1wo6TZGU0GdGcw6vAk7_RTZwmEgO_ywqd)

flashtech
31st December, 2017, 11:21 AM
I think that You need to find BDM read and then try to write it on bench with K-TAG.

voltechcar
31st December, 2017, 06:59 PM
use revocery with kess by obd, car dont start to write K-tag because many device have big problem to crc this ecu.

peko
27th March, 2020, 03:27 PM
hi friends

i have exactly same probleme, 50% writing and crash eeprom

how you solve it ?
i'm looking for data from eeprom to compare

when i connect again kess, i have error message not know HW