MB Sprinter CRD2-651 NEED TVA OFF

[Yura123]

Hi, need help.
Blinking malfunction lamp. After removing P2119 errors from the file, there are no errors, but the lamp still flashes. Help remove the TVA correctly.

Thanks in advance.
THK+REP

[johak]

I'm not 100% sure


if it works then press magic buttons :)

[Yura123]

I'm not 100% sure


if it works then press magic buttons :)


Hi, not work.

[Ignasvw]

Try this and give me report. i think i have one more shot

[Yura123]

Try this and give me report. i think i have one more shot
Thanks, but

Error P2119 in your file are not correctly deleted.



I replaced now a new TVA, star dianostic - no errors, but the fault lamp flashes.

I started the car several times, drove 15 km.

I do not understand what kind of problem.

I want to remove the flashing on the original file, then write without TVA.

[Ignasvw]

i tried to fix your limp mode not dtc

[Yura123]

i tried to fix your limp mode not dtc

No limp mode. The car goes without any problems. Оnly blinking lamp

[Ignasvw]

wait i will fix lamp

[Ignasvw]

try this one. pass same

[Yura123]

try this one. pass same

Thanks, but I replaced now a new TVA, star dianostic - no errors, but the fault lamp flashes.

There is some other reason, other than the TVA, why flashing lamp

[Ignasvw]

write original file

[Yura123]

I writed original, problem on the original file

[gitko]

This is hard work to be done but is can be make and without TVA this car and without flashing the check

[phl0at]

If you have new TVA, install it, go to adaptations in DAS and reset MAF, adapt new air filter and EGR adaptation. Will stop flashing ;)

[Yura123]

The solution is the following - the original file turned out to be someone incorrectly modified. Restored the original and disabled DPF correctly, the lamp stops blinking.