st10

[mohamad1401]

hi all DK

PLEASE it's possible to read st10f276 by xprogm 5.55

thanks

[lwd11]

Hi

Propably yes with authoritation, look http://www.xprog-m.com/product.php?id_product=23

[mohamad1401]

thanks

I tried this and did not succeed .. Please where is the problem !

[attilaa0]

Hi!It can be read by TNM5000 via ISP.
But from what device is this MCU?thanks!

[mohamad1401]

Thank you I use xprog m 5.55 for read mcu st10f276 for rns 510


I do not have programmed TNM5000 ;(

[neverseenpotato]

Hi mohamad,
use external power supply 5V 1A, you get from programmer 5V 0.1A, the current may be small

[mohamad1401]

Yes I used it 5v 1A


Without result

[exe123]

Xprog is using BSL mode. For this you need to read it incircuit. It will never work on adapter board because xtal is missing and ST10 is not running!

[mohamad1401]

thanks

possible to read incircuit rns510 !

[exe123]

http://help.martech.pl/sites/pliki/files/rns510_st10f.png

[mohamad1401]

Thank you


I tried it did not work !!

Sorry For Disturb

[exe123]

try swap rx and tx

[ahmetusta61]

xprog programmer connect 12 volt

[mohamad1401]

thanks

i swap rx and tx didn't work !!


I tried 12v to xprog didn't work !!

[exe123]

Xprog has option for xtal frequency. In your screenshot it is 4MHz. Check RNS510 PCB if ST10 xtal is 4 MHz otherwise you need to change value in Xprog - environmental settings

[mohamad1401]

thanks

i changed frequency to 4MHZ didn't work !!

[eFighter]

Does someone solve this problem?

[madlion]

Yes. I read it with Orange5

[matociso]

Yes. I read it with Orange5

you read with orange5 with st10 on mainboard or in adapter outside from mainboard?

[Roepps]

I looking for a programmer i can flash the ST01f276 on the board. i don't will buy the product from Martech, i am a beginner und will only repa my one board wit the gateway problems.
Some one a idea wath grogrammer i can use?
I'm also intrest you read on or outside the mainboard with the ORANGE5?

[GanPower]

Someone that read and write with success ST01F276 with xprog or orange5 ?

[kostelectronics]

Orange 5 works in circuit! Just done now. The Logic1-Pin is not required :)

[volodin69]

Search st10Flasher on internet and use j2534 tool. Good luck.