problem with smock uhds for bsi psa i pay

[Stefanomilano]

hello my friends i have a big problem with smock i wanted to do a bsi cloning by reading eprom and flash when i put give eeprom in the other bsi on the table the bsi do not wake there is there a boot mode or mode recovery because the smock no longer want to flash again bsi please help me I pay if someone gets to repair me thank you

[wissamshaat]

what is the bsi brand??
did you tried just to swap eeproms?
or make a virgin bsi and telecode againe with diagbox

[Stefanomilano]

what is the bsi brand??
did you tried just to swap eeproms?
or make a virgin bsi and telecode againe with diagbox

Jc control h02 easy can 4
it's the smock that kill the bsi is there a boot mode?
Yes change eeprom works but the problem and that smock has finished writing new eeprom in new bsi and now impossible to reread the bsi with diagbox that smock recognize the bsi but now do not want to write again as if the bsi was blocked by the smocking

[wissamshaat]

jc control are shit with almost all of tools
even smok they say that its not all suporrted with the tool

[Stefanomilano]

jc control are shit with almost all of tools
even smok they say that its not all suporrted with the tool

You would like to say that the copy is not complete I copy that eeprom and by being the same to give that origin the car does not start loves me if you change the eeprom it is Virginize only I pence that smock and no one for jc but if there is boot mode like on it terminal and well I could save bsi