Boxer III after 2006 immo off

[PSAcars]

Hello to all. Can some one make immo off or auto coding virgin for this ecu?

[vladanr]

507696 here you are ,it is autocoding ,only have to program injectors after

[PSAcars]

Hi vladanr your file is bigger then mine. I read it with Xprog-M (832KB) and your's is (896KB) may be for galleto or k-tag?

[vladanr]

Hi vladanr your file is bigger then mine. I read it with Xprog-M (832KB) and your's is (896KB) may be for galleto or k-tag?

yes you must write with galleto

[PSAcars]

I dont have Galleto:giveup:

[vladanr]

you can delete last lines in hex editor and make same size

[PSAcars]

Yes but I think the offset is not in the last lines, I took a look in hexcmp and the file is different.

[vladanr]

may be ,I am not in service now and have not any program here,till monday

[PSAcars]

Ok If you have other solution I be here.

[vladanr]

In this post
http://www.digital-kaos.co.uk/forums...STEON+GALLETTO

you can found file of Visteon Ecu read in CAN, K, and xprog.

Length of Xprog is 832k, other is 896K.
Comparing the files I found that the segment of ram 64k is
inserted starting at address 8000h .
So I created a file of 64K to all FFh ( 0000h to FFFFh ) , put
it in Xprog file starting at address 8000h and saved all.
The length of the new file is 896K .
The new file and the file reading in CAN are the same.
I think this is the solution.

[PSAcars]

Hello. Yes this is solution for making Xprog file to galletto. I tryed to remove data from 896k (Galeto file) from address 0000x8000 to 000x17FFF and I get the 832k file. Like this I will try. About my file, " vladanr " this is not my file cleared, is this some template? I see big regions with differences?