View Full Version : Lupo 1.4 EDC15P MAP sensor linearisation
Fec001
22nd February, 2018, 04:16 PM
Hi!
Can you help with mod MAP sensor linearisation to 3 bar? I think I found the correct map but not sure.
Thanks!!!
Ignasvw
22nd February, 2018, 04:18 PM
post file here
sdtsedat
22nd February, 2018, 04:23 PM
You can use map "OVERBOOST" in ecm titanium, and check the adres so you can use these in WinOLS.
fzhut
22nd February, 2018, 04:46 PM
Hi!
Can you help with mod MAP sensor linearisation to 3 bar? I think I found the correct map but not sure.
Thanks!!!
Yes, it's MAP linearisation. Don't forget to switch car to MAP Smoke calculation if going to boost higher - ori MAF is as far as i know till 1000 mg :)
synmnicha
22nd February, 2018, 05:24 PM
Hi!
Can you help with mod MAP sensor linearisation to 3 bar? I think I found the correct map but not sure.
Thanks!!!
82 951
200 3000
Fec001
22nd February, 2018, 05:36 PM
1.4 TDI use MAP based smoke limiter from factory as I know.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.