View Full Version : Pcr 2.1 polo 6r 1.6 tdi read unlock write
pluto2013
24th February, 2018, 09:53 AM
Helo Guy's
I have today A friend with polo.
Is this he right procedure to do this with kess?
1- read file And id with obd
2- open ecu add resistors And read eeprom with tricore.
3- unlock only one time
4- put back ecu in car And write by obd?
Thnx
boomeer
24th February, 2018, 10:20 AM
Yes it's ok ! You can now read write by obd
DR Race
24th February, 2018, 10:56 AM
Helo Guy's
I have today A friend with polo.
Is this he right procedure to do this with kess?
1- read file And id with obd
2- open ecu add resistors And read eeprom with tricore.
3- unlock only one time
4- put back ecu in car And write by obd?
ThnxIf you have Ktag no need for resistor!
Trimis de pe al meu SM-G930F folosind Tapatalk
DR Race
24th February, 2018, 11:00 AM
After opening , conect ecu to car and start the motor, when not opened with care can damage electronic components, and in this whay you will know if your hardware is ok after opening , if something goes bad by flashing , you can not now exactly where is problem , hard oder soft!
Trimis de pe al meu SM-G930F folosind Tapatalk
pluto2013
24th February, 2018, 11:24 AM
If you have Ktag no need for resistor!
Trimis de pe al meu SM-G930F folosind Tapatalk
Also with ktag clone
DR Race
24th February, 2018, 12:37 PM
Also with ktag cloneThat I don't know, for this ecu I use CMD Flashtec , it does all over OBD, no need for opening, I have done with Ktag ori and no problem, if you don't trust your clone then better with resistor!
Trimis de pe al meu SM-G930F folosind Tapatalk
ozumborris
24th February, 2018, 09:55 PM
i have same car...i have clone ktag..so no need to open ecu right?
i will connect it directly to obd and read...then write? is it ok? thanks..
DR Race
24th February, 2018, 10:20 PM
i have same car...i have clone ktag..so no need to open ecu right?
i will connect it directly to obd and read...then write? is it ok? thanks..No is not ok , with clone you have to open ecu, unlock on bench then after unlock you can read/white over obd port! Falow instruction show on your ktag and all ok !
If ecu already unlocked then you can direct obd , ktag dont work obd !
Trimis de pe al meu SM-G930F folosind Tapatalk
ozumborris
24th February, 2018, 10:42 PM
thanks..can you suggest me a obd a cable for ktag? (wv polo 1.6tdi pcr2.1)
DR Race
24th February, 2018, 10:49 PM
thanks..can you suggest me a obd a cable for ktag? (wv polo 1.6tdi pcr2.1)Ktag dont work obd , you have to do it with kess v2 , or any othere obd tool , ktag not support OBD!
Trimis de pe al meu SM-G930F folosind Tapatalk
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.