PDA

View Full Version : Passat b6 ppd1.5



petdog
28th February, 2018, 02:37 PM
Hi
I need dtc remover PASSAT B6 2.0TDI
SIEMENS PDD1.5G
P1592 18000 005522
THX FOR HELP

Inquizit0r
28th February, 2018, 02:43 PM
Here it...

bobolin4o
28th February, 2018, 03:00 PM
Hi
I need dtc remover PASSAT B6 2.0TDI
SIEMENS PDD1.5G
P1592 18000 005522
THX FOR HELP

If you have P0000 now... you can use my file.
And... btw, it will be good to find the reason of this DTC, not just - "please remove it"!
Regards!

petdog
28th February, 2018, 03:26 PM
czy możesz usunąć tryb awaryjny? usterka znajduje się wewnątrz ecu, ponieważ po wyłączeniu zapłonu ten błąd świeci po skasowaniu jest w porządku, dopóki zapłon nie zostanie wyłączony

18000/P1592/005522 - Altitude Sensor / Boost Pressure Sensor: Implausible CorrelationPossible Symptoms

Malfunction Indicator Light (MIL) active
Limp Mode active

Possible Causes

Ground Spots corroded
Wiring from/to Boost Pressure Sensor (G31) faulty
Boost Pressure Sensor (G31) faulty

Possible Solutions

Check/Clean Ground Spots
Check/Replace Wiring from/to Boost Pressure Sensor (G31)
Check/Replace Boost Pressure Sensor (G31)

Special Notes

When found in 2.0l TDI-PPD, check for matching TSB/TPI (i.e. VW TPI 2012601 and/or 2026831).

Check/Clean Ground Spots
Check/Replace Wiring Harness for Boost Pressure Sensor (G31) and Intake Air Temperature Sensor (G42)
Check/Update Engine Control Module Software/Firmware

bobolin4o
28th February, 2018, 03:31 PM
1. Check plausibility of MAP sensor to AP sensor with ignition on and engine off.
2. Clean, or replace the MAP sensor.
Job done!

Or test both files... if you too lazy to fix the problem...

petdog
28th February, 2018, 03:33 PM
I did everything including new leads and map sensor

bobolin4o
28th February, 2018, 03:36 PM
Obviously you didn't do enough...
Any way, did you test the files?

petdog
28th February, 2018, 03:38 PM
i tested now

sida
28th February, 2018, 09:01 PM
change ecu