IVECO Bosch MS6.3 Immo off

[mgmotorssligo]

bosch ms6.3 iveco 2004.

eeprom 24c16

Any working solutions, please?

Thanks
MG

[Pyromaniak]

here, try it. remove immo box. If working press buttons :02.47-tranquillity:

[Metelkov]

Hello Piromaniac. Could i ask for help me.
I have now in my garage the Iveco daily 2001 m.y. ms6.3 35c13 2800 cc.
I don't now where is native ECU this car and so i have some trouble with IMMO.
i wanna kill the immo.
Tell me please the order of action please.
read eeprom only or eeprom and flash?
i have kess and ktag, but i can read it in car - wake up error or change session not possible on bench mode.
Honestly it is blowing my mind now)
thanks for any help

[ZiZiTun]

hi, you must read eeprom 24C16. I think, that Ktag dont support to read this eeprom from ECU. Use programmer.


Hello Piromaniac. Could i ask for help me.
I have now in my garage the Iveco daily 2001 m.y. ms6.3 35c13 2800 cc.
I don't now where is native ECU this car and so i have some trouble with IMMO.
i wanna kill the immo.
Tell me please the order of action please.
read eeprom only or eeprom and flash?
i have kess and ktag, but i can read it in car - wake up error or change session not possible on bench mode.
Honestly it is blowing my mind now)
thanks for any help

[Metelkov]

Thank You, I've read it. But i don't know how send ZIp to this Chat

[Metelkov]

I've read, then used IMMDEC3.2 for repair data, then reprogrammed it to eeprom and resolved it to ECU. i disconected immobox above brake pedal. But i don't have "-" from 8 pin A-cab connection.
ECU is connected to Delphi scanner, i see 12 parameters.
if i connect 8 pin to "-" - my fuel pump run for 5-8 sec.
Actually i can't start now because all 4 injectors are broken and have been repairing now in another service. I'm affraid that after replacement injectors i won't start this car.

[Metelkov]

There are my files from eeprom

[Metelkov]

I think that I solved this case with my fuel pump: additional to problem with IMMO i have bad 8 pin in A-connector inside a ECU. I resoldered all pins and made good negative contact instead 8 pin.
Now KOEO - my fuel pump is working according manufactory setting)
Thank to all.
Immo box i've removed - it is right above brake pedal.

[Metelkov]

The problem is solved totally. The Vehicle works perfectly despite SHE is 21 old)))
Thank everyone for help me)