MG ZS all key lost

[EMCE159]

Hello
Can anyone help with this weird car? Cannot connect to it with t300. It has remote module near gear switch. Car starts to crank when I join pins 2 and 23. So far so good, but it has engine 2,5 l and ecu siemens NNN100655 S108847002B. And only flash in it, and according to google immo off impossible. Weird thing with this car is that it has coil on ignition switch. Should I look somewhere for EWS? Because I remember that I replaced this kind of ecu in rover 75. Car is 2003.
Thanks for any help.

[Weasel3]

MF ZS = Styled Rover 45

[coolsoda]

T300 does not work with rover unless you buyor make the lead
http://www.digital-kaos.co.uk/forums/showthread.php/47726-rover-t3oo-remote-lead-pin-outs

[EMCE159]

T300 does not work with rover unless you buyor make the lead
http://www.digital-kaos.co.uk/forums/showthread.php/47726-rover-t3oo-remote-lead-pin-outs

Thanks my friend, I'll give it a try.

[Eskerra]

@EMCE159.
Have you identfied first if your car is LUCAS or PEKTRON system ???

Regards

[Cr4nky]

The coil round ignition switch is for passive disarming of immobiliser (excites remote to send unlocking signal). If it's lucas, then simple job, just program remote. If pektron you will not be able to communicate with module when immobiliser active. Remove module and add new remote via eeprom.

[EMCE159]

T300 does not work with rover unless you buyor make the lead
http://www.digital-kaos.co.uk/forums/showthread.php/47726-rover-t3oo-remote-lead-pin-outs

Thank You my friend. It was lucas system, worked like a charm.