PDA

View Full Version : Renault 2.0 16V Sirius32n +CAN disable immo


etronic2
6th November, 2009, 04:08 PM
Hi lads,

I'm looking for solution how to disable im*o on Sirius32n with CAN bus transciever. Found info that this is not possible unlike on 32n without CAN bus.

Can anyone confirm that?

Is there a way to obtain a PIN no from ECU?


Thanks
Sam-F
6th November, 2009, 06:41 PM
not sure about getting pin from ecu but you can get it from the 93c66 in the uch ( fuse box)
busaman
7th November, 2009, 09:46 AM
i have a file that will do it but you will have to remove 29f200 of the circuit board and reprogram it then cut wire to pin 58.
baykalaras
7th November, 2009, 12:51 PM
send dump file
etronic2
8th November, 2009, 06:58 PM
AFAIK ECU frim 16V with CAN transciever can be done but i can't find any info about it. None tricks from otto or immo tool works neither with emulator or without.

I've attached ori dump from f200.
baykalaras
9th November, 2009, 10:47 AM
iimmo off dump
szwajcarek
11th November, 2009, 12:09 PM
Hi
I am also interested in this solution so please reply if it is working or not.

Regards
etronic2
11th November, 2009, 11:05 PM
iim*o off dump

From picture included i can see that this is not a solution for this ECU with CAN (no CAN transciever in that ECU). Dump looks like generated by ottocheck or other programs...
szwajcarek
12th November, 2009, 09:02 PM
Hi
I am affraid that it is impossible to by-pass immo in Sirius32 with can transciver (A82c250) even with emulator

Regards
AC_SHNITZER
21st March, 2010, 12:11 AM
iim*o off dump
sorry but your solution with that dump not worked on sirius32 or sirius32n 100% tested today with or without two elements of attached picure . Without emulator on 2.0 16v - no chance :dontknow:
AC_SHNITZER
21st March, 2010, 12:16 AM
etronic2 what is your gearbox , manual or automatic ?
etronic2
22nd March, 2010, 01:01 AM
It's manual mate...
AC_SHNITZER
28th March, 2010, 10:57 PM
Why not just try dump without can for test ?
asso
29th March, 2010, 10:52 PM
hello I would like to use decode a sirius 32 immokiller.che do you think?
AC_SHNITZER
30th March, 2010, 10:06 PM
must work but not sure without emulator
etronic2
30th March, 2010, 11:02 PM
Why not just try dump without can for test ?


I have tried the one for older ECU's but no luck at all....
x-tech
29th April, 2010, 04:49 PM
to remove im*o sirius 32 , just need a pen-test led, make jumper on 18 and 19 pin of psop from Ecu, do it fast and many times, and star ignition in the same time, when run motor im*o is off, then cut line 58 (im*o) or remove the resistor in Circuit of 58 line, that?s ok, no need more im*o, if you connect the 58 line again, im*o wil bee on. this procedure is 100% warranted