Wich Tool can Read Eprom in Circuit / on PCB?

[Astraracer]

Hello,
I tried to solder the EPROM from the board from my Opel CD70. But the glue under the Eprom is very strong. I can not get it solved. Is there a tool that can read this (24C64) and possibly other EPROM on the PCB? What can you recommend me?

Regards

[richiebb]

It depends on the circuit. After reading a couple of eeprom badly I always take them off the board. I recommend a hot air soldier station

[Astraracer]

It dont work with SMD Reworkstation, because the Eprom is glued with extrem strong Epoxy Glue from Factory!

[yugo45]

It can be done, just need to know how.
All ME2.8 mercedes and VAG Me7.1.1 CAN ECU eeoroms are like that .
Heat it for about 3-5 min with 280-300 , then use Needle nose Pliers and twist left/right very slowly( very small turns ) and eventually will come off.

[rafal]

It dont work with SMD Reworkstation, because the Eprom is glued with Epoxy Glue from Factory!

buy some used ecu and try to learn

[Astraracer]

I Make this Many Times (for Example at ME7.x) allways works but in This Case it DONT work without Distroy! But i See Nobody unterstand that and nobody Knows in Circuit Programmer.

[RadioChiP]

Try short Osc Pins
Power on Read again