gerardo4r
4th March, 2018, 02:10 PM
Hi
I was able to erase EEPROM and show 0 degree and erase DTC errors and did the zero point calibration procedure, after this the EPS and SLIP light went off, but when I moved the steering wheel again the EPS and SLIP lights up, I move the steering wheel to the center, I turn off the car and when I turn on the lights of EPS and SLIP are off, I turn the steering wheel and again turn on the lights of EPS and SLIP, could someone tell me what may be happening ???
Toyota 4Runner 2012
Part Number Angle Sensor 89245-30110
EEPROM 24c02
I hope someone can help me, thank you very much.
Gerardo
I was able to erase EEPROM and show 0 degree and erase DTC errors and did the zero point calibration procedure, after this the EPS and SLIP light went off, but when I moved the steering wheel again the EPS and SLIP lights up, I move the steering wheel to the center, I turn off the car and when I turn on the lights of EPS and SLIP are off, I turn the steering wheel and again turn on the lights of EPS and SLIP, could someone tell me what may be happening ???
Toyota 4Runner 2012
Part Number Angle Sensor 89245-30110
EEPROM 24c02
I hope someone can help me, thank you very much.
Gerardo