PDA

View Full Version : FIAT DUCATO VISTEON DCU 102 virgin


ilian_cho
19th March, 2018, 03:09 PM
Hi to all. I have fiat ducato wit DCU 102 100HP. I need virgin ecu. I try with immo decoding -not work. Try to reset only immo code - not work. Post original dimp and other two that i try.
nikostzimis
19th March, 2018, 03:42 PM
The corect file is Size: 896Kb and yours 832kb ???? try reade again!! to virgin ecuvonix!!!!!!!!!!!!! :peaceful:
Uploade file here to help you
Regards
Nikos
ilian_cho
19th March, 2018, 05:05 PM
I found another post and size is same. look:
http://www.digital-kaos.co.uk/forums/showthread.php/649244-Fiat-Ducato-Visteon-DCU-102-IMMO-Virginise?highlight=VISTEON+DCU+102
http://www.digital-kaos.co.uk/forums/showthread.php/636868-DUCATO-VISTEON-DCU-102-VIRGIN-AUTOSYNC?highlight=VISTEON+DCU+102
ilian_cho
19th March, 2018, 05:09 PM
Try to read with K TAG and ORANGE-832 Kb
With VVDI lengh is same-832 kb.
May be i make mistake?
nikostzimis
19th March, 2018, 05:21 PM
yes...
I have original immo decoder 4.5 i try to vrgin file but tells me the file is not correct!!
nikostzimis
19th March, 2018, 05:25 PM
checked kb Galletto?????
Look this
http://www.digital-kaos.co.uk/forums/showthread.php/309086-Problem-flashing-JUMPER-Visteon-DCU-102-2-2-HDI-with-Galletto-2-in-boot-mode

I think to help you to read correctly 896kb With Galletto v54!!!!:hello:
R...s
Nikos
baltazar3
19th March, 2018, 07:29 PM
Hi to all. I have fiat ducato wit DCU 102 100HP. I need virgin ecu. I try with immo decoding -not work. Try to reset only immo code - not work. Post original dimp and other two that i try.
Here is Your file...write with FGTech boot mode...pm
ilian_cho
20th March, 2018, 04:12 PM
For all: File DCU_102_virgin_2 work. No need injector coding no need pump adaptation. My problem was water in ecu conectors. Thanks to BALTAZAR3 and NIKOSTZIMIS for the help
ilian_cho
20th March, 2018, 04:28 PM
And for all that have problem with size: Flash in ST10F276 is 832kb read with oranfe vvdi k tag even x prog. When is readed with galletto size is 896kb. but after adres #CFFFF no data only FF FF .......FF. So important data is betwen 00000 and CFFFF.
systemlinux
26th November, 2019, 04:09 PM
then biscuit reads the complete info without cutting the file size (delete data)
tecnocar
19th December, 2019, 12:38 PM
THANKS friend Ilian_cho
IT WORKS PERFECTLY