nps1994
19th March, 2018, 03:53 PM
Hello dear members,
i am planning to convert my Lupo 3L to a manual gear shifting system instead of the automatic system which is fitted now. This is due to the upgrades sport clutch i am planning to fit, because the automatic clutch actuator simply can't pull it. Also, the system is not very liable.
I have found the manual file from pinotec/bumbastic from this forum
(www.digital-kaos.co.uk/forums/showthread.php/373912-Lupo-3L-ecu-software-with-manual-gearbox)
and since i found that the drivers wish and som other maps weren't similar to the stock 3L one, i have adapted them. However, DW map is different in the Polo ECU, so i had to adapt it by using interpolation.
(Will attach the file once i get to my workshop PC).
I made all these changes and flashed it into one of my spare ECU's, and bench test went OK. When fitted to the car, and all automatic gear system disconnected, VCDS reads all sensors (Tested with measuring blocks), however it thows 2 troublecodes: Steering angle sensor, and ECU defective (Fault in EEPROM communication - Will also attach these as soon as i get to my workshop PC).
So what i'm now am asking for is help for getting this file up and running. Is it because the flash looks for wrong addresses in the EEPROM (since it is a Polo flash?)
Your help with this would be much appeciated. Have a great day, and thanks in advance.
i am planning to convert my Lupo 3L to a manual gear shifting system instead of the automatic system which is fitted now. This is due to the upgrades sport clutch i am planning to fit, because the automatic clutch actuator simply can't pull it. Also, the system is not very liable.
I have found the manual file from pinotec/bumbastic from this forum
(www.digital-kaos.co.uk/forums/showthread.php/373912-Lupo-3L-ecu-software-with-manual-gearbox)
and since i found that the drivers wish and som other maps weren't similar to the stock 3L one, i have adapted them. However, DW map is different in the Polo ECU, so i had to adapt it by using interpolation.
(Will attach the file once i get to my workshop PC).
I made all these changes and flashed it into one of my spare ECU's, and bench test went OK. When fitted to the car, and all automatic gear system disconnected, VCDS reads all sensors (Tested with measuring blocks), however it thows 2 troublecodes: Steering angle sensor, and ECU defective (Fault in EEPROM communication - Will also attach these as soon as i get to my workshop PC).
So what i'm now am asking for is help for getting this file up and running. Is it because the flash looks for wrong addresses in the EEPROM (since it is a Polo flash?)
Your help with this would be much appeciated. Have a great day, and thanks in advance.