IAW5SF3.M2 killed by swapping eep data

[honingkoning]

Guys i tried to clone a 5SF3.M2 ecu with i/o terminal.
I Could read ecu eep en flash and i wanted to transfer this data to ecu from scrapyard.

I transfers emulated eep and from that moment ecu is dead.

I opened ecu and tried by putting 2 100ohm resistors, also no help.
I tried to read st10F280 with martech also impossible.

Is there a way to save this ecu? Maybe xprog or Some different connections for martech ?

All advice is welcome.


Btw virgine is not the same like Punto 168 or first Stilo?

I made ecu virgine first But i wont auto adapt.

Wbr Adam.

[Meat-Head]

More likly soldering issues or bad connection on EEPROM

[honingkoning]

More likly soldering issues or bad connection on EEPROM

I was hard to solder the eeprom on the st10F280 [emoji1][emoji1][emoji1].

Very small and hidden.

[Locksmith Hungary]

"ß$¤ßłpúőpúßßłŁ$ßßłjáßßłßł$×÷łŁł¤ß=

[antwnhszr]

if you have ktag select the correct pcb and on the RESET cable from the ktag put one resistor 100ΩΜ......read without any problem

[AlfaRed]

Boot for FGTech..

[mikroel]

I was hard to solder the eeprom on the st10F280 [emoji1][emoji1][emoji1].

Very small and hidden.

Virgin can be done with marelli decoder too.


Sent from my iPhone using Tapatalk

[honingkoning]

if you have ktag select the correct pcb and on the RESET cable from the ktag put one resistor 100ΩΜ......read without any problem

Can you share this pdf (No pdf in my ktag)

I test like this.

Wbr

[honingkoning]

Can you share this pdf (No pdf in my ktag)

I test like this.

Wbr

Guys i can read by ktag, Lets see if i can restore it.

Wbr Adam.

[honingkoning]

Guys i Could save ecu, i write ori eep back with ktag.

Eep starts from 04000 till 7ffff.

Thanks Guys.