PDA

View Full Version : Polo pcr2.1 idle rpm increase



looly
26th March, 2018, 12:44 PM
Hi
I've got a polo 2010 1.6tdi CR which idles fine when cold but after a few minutes idle becomes very lumpy. If i increase rpm to 830rpm then it is smooth again. Is anyone able to increase the rpm on this pls? If yes then i will take a read.
Many thanks

Vasily.U
26th March, 2018, 01:30 PM
You can change map 4x8 ip_n_sp_is_at like you need.

looly
26th March, 2018, 02:21 PM
Thanks. If i take a read would you be able to alter it pls?

Vasily.U
26th March, 2018, 02:32 PM
Yes sure....

looly
26th March, 2018, 02:59 PM
Thanks mate. I'll take a read later and look. If i get stuck I'll post dump here. Many thanks.

sdtsedat
28th March, 2018, 01:30 PM
You can do this with delpy in settings

chli1976
29th March, 2018, 01:16 PM
Thanks mate. I'll take a read later and look. If i get stuck I'll post dump here. Many thanks.

Not with the last SW.

Post you result with new idle speed. Have done a Octavia, but idle speed is for the first 10 sec on old value (780) and after 10 sec idle speed has new value (870)

souf5z
5th May, 2020, 01:28 AM
You can change map 4x8 ip_n_sp_is_at like you need.

Hi. I have the same problem here (PCR2.1 cayb). Where did you find this map ? I'm using winols and i didn't found the address you are talking about. If you can give me a more detailed answer....thank you

best regards

souf5z
7th May, 2020, 06:37 AM
Hi. I have found the map you were talking about. But to increase my idle (rpm) i don't understant what to modify in the values...?


see attached image : https://ibb.co/47V324G
regards