Bricked ECU edc17c59 Opel

[sdtsedat]

Hi people, today i tryed out to read opel corsa 1.3cdti 2013 with edc17c59

I use resistors to connect boot with ktag. When soldering i brick ellement on ecu see in picture.

So now i cannot connect with ecu, is there any other thing to read out this ecu? Car start.

https://uploads.tapatalk-cdn.com/20180329/36090dd2714170d2a9dc89fe989da0c6.jpg

Verstuurd vanaf mijn SM-G955F met Tapatalk

[maajkii]

connect to path with niddle

[baltazar3]

You can read it with different tool

[sdtsedat]

What do you know different tools? I try read with kess geniune no read.
@Maajki: You think the paddels are ok? I try out with good resistor tomorrow i think 470ohm + 470ohm and boot pin, gpt, etc etc
correct me if i am wrong..

[morgano]

The trace on the right of the blown pad seems good place to attach (based on the picture), better resolution would help more to find accurete spare point. Scratch it a bit to expose copper and solder there.

`http://www.digital-kaos.co.uk/forums/attachment.php?attachmentid=517814&d=1522368553

[Myjector]

You can solder an new copper pad on it, clear the pad to it and solder it
Ho high you put the temperature of your solder equipment? put it max 365°c and always use flux for soldering

[rh03]

why you solder resistor directly on ECU, it's better and more safe with pogo pin

[baltazar3]

What do you know different tools? I try read with kess geniune no read.
@Maajki: You think the paddels are ok? I try out with good resistor tomorrow i think 470ohm + 470ohm and boot pin, gpt, etc etc
correct me if i am wrong..
X17 use different points for resistors ...so my advice:find nearest tuner to help you.

[sdtsedat]

I try today witch scrating and use 570ohm resistors. No reading.

I buy adapter from ecubay for check and give feedback.

Verstuurd vanaf mijn SM-G955F met Tapatalk