PDA

View Full Version : Question about edc17c41 bmw 520d f10



sdtsedat
11th April, 2018, 11:40 AM
This car is coming today but there is no vr read available in alientech..

So my question, if i give ecu id someone can check it in autotuner of magpro/cmd for ori file and can i flash that file?

Any risk?
Otherwise i need to drill this ecu..

Verstuurd vanaf mijn SM-G955F met Tapatalk

Ignasvw
11th April, 2018, 02:21 PM
Are you sure you need to drill this ecu? its not edc17cp45

sdtsedat
11th April, 2018, 04:19 PM
Are you sure you need to drill this ecu? its not edc17cp45I know it is edc17c41, magic sell drilling tool.
Riskly operation?

Verstuurd vanaf mijn SM-G955F met Tapatalk

Ignasvw
11th April, 2018, 04:20 PM
I know it is edc17c41, magic sell drilling tool.
Riskly operation?

Verstuurd vanaf mijn SM-G955F met Tapatalk

I rather remove pcb from that case


Sent from my iPhone using Tapatalk

sdtsedat
11th April, 2018, 04:22 PM
I rather remove pcb from that case


Sent from my iPhone using TapatalkHoh.. this pcb is flipped and boot pin is under so i need turn backside pcb

Verstuurd vanaf mijn SM-G955F met Tapatalk

mircea13
14th April, 2018, 12:08 AM
And that is a verry risky job. Seen some cars that after a weak ecu was dead after flip. Safest way is to drill it. Why don't do it boot mode? why bother with kess obd? do it with ktag. But what are the connections??? I also have a 2010 520d 163hp edc17c41 gpt and Ktag gives me multiple connection ways and protocols for this ecu. Does gpt1 and gpt2 need to be soldered / probed on the pcb?? or i can connect the on correspoding gpt1 and gpt 2 ecu pins for this edc17c41 gpt ?