2005 VW TDI EDC16U34, asv delete, need some codes removed from ECU please,,ty

[BRMTDI]

Here is file just need last codes removed.....I would do myself but not really sure how...

EDC16u34, 2006 Jetta TDI, BRM Engine Code TDI.

Remaining Faults, Address 01: Engine Labels: 038-906-016-BEW.lblControl Module Part Number: 03G 906 016 AB HW: 028 101 223 8
Component and/or Version: RC s01f EDC G000SG 7550
Software Coding: 0050071
Work Shop Code: WSC 66565 257 00032
VCID: 638667EDA2B36D5C65-8036
3 Faults Found:


001031 - EGR Sensor 2
P0407 - 000 - Signal too Low
Freeze Frame:
Fault Status: 01100000
Fault Priority: 0
Fault Frequency: 1
Reset counter: 255
Mileage: 476015 km
Time Indication: 0
Date: 2012.08.28
Time: 00:09:44


Freeze Frame:
RPM: 966 /min
Speed: 0.0 km/h
Load: 0.0 %
Lambda: 0.0 %
Mass Air / Rev.: 850.0 mg/str
Mass Air / Rev.: 475.0 mg/str
Bin. Bits: 00000000


008214 - Intake Manifold Flap Position Sensor (Bank 1)
P2016 - 000 - Short to Ground
Freeze Frame:
Fault Status: 01100000
Fault Priority: 0
Fault Frequency: 1
Reset counter: 255
Mileage: 476015 km
Time Indication: 0
Date: 2012.08.28
Time: 00:09:44


Freeze Frame:
RPM: 966 /min
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 14.21 V
Mass Air / Rev.: 475.0 mg/str
Duty Cycle: 95.1 %
Bin. Bits: 00000000


005269 - Switch-Over Valve for EGR Cooler (N345)
P1495 - 000 - Open or Short to Ground
Freeze Frame:
Fault Status: 01100000
Fault Priority: 0
Fault Frequency: 1
Reset counter: 255
Mileage: 476015 km
Time Indication: 0
Date: 2012.08.28
Time: 00:09:45


Freeze Frame:
RPM: 966 /min
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 14.29 V
Bin. Bits: 00101000
Mass Air / Rev.: 850.0 mg/str
Mass Air / Rev.: 475.0 mg/str

[ohkarol]

this file is not read correctly, which tool did you use to read ?

[johak]

here is these 3 dtc deleted p0407 p2016 p1495

[BRMTDI]

this file is not read correctly, which tool did you use to read ?VVDI2 do I need to bench ECU I assume thought I could read full flash via OBD2

Sent from my SM-G955U using Tapatalk

[BRMTDI]

VVDI2 do I need to bench ECU I assume thought I could read full flash via OBD2

Sent from my SM-G955U using TapatalkTuner wrote do not read script in file if your trying to mod with winOLS but that's easy to remove I can remove and send you it or try the winols can read.

Sent from my SM-G955U using Tapatalk