View Full Version : mitsubishi pajero 2006 ecu table connection
ezenigbo
13th April, 2018, 05:44 AM
please how can i get table connection of this ecu to tactrix open port 2.0,ecu type MR560020 with MH8305F inside
Samsara
13th April, 2018, 05:43 PM
Hello.
What is the purpose ?
This ECU has K-Line.
ezenigbo
14th April, 2018, 06:21 AM
yes i want the kline,positves,negatves,i just ~~~~ to do ecu replacement,if i can read the old ecu and write to new ecu
moky
14th April, 2018, 06:35 AM
hi
here ktag pinout
https://ibb.co/jtTrZ7
ezenigbo
14th April, 2018, 07:01 AM
thanks,but where should i connect VPP at the ktag obd sucket
Samsara
14th April, 2018, 09:37 AM
K-TAG is not by OBD
moky
14th April, 2018, 11:55 AM
of course but pinout is pinout..
vpp is high voltrage I think +16/17V but if someone can confirm..
Samsara
14th April, 2018, 12:28 PM
of course but pinout is pinout..
Sorry, i don't understand.
There's no VPP access via OBD, only K-Line.
Kess cannot read it.
ezenigbo
14th April, 2018, 06:01 PM
the ecu is thesame 4 sucket like mine but mine each sucket has 3 line insted of 2 line as you gave me
philipcoin
14th April, 2018, 06:06 PM
mate post picture of you ecu
ezenigbo
14th April, 2018, 07:37 PM
tis is the ecu
ezenigbo
14th April, 2018, 08:29 PM
that is the cove
Samsara
15th April, 2018, 08:23 AM
Sorry, your ECU is for 3.5 GDI , Moky and me talking about 3.2 DID ECU.
Here the connexions of your ECU for K-Tag.
ezenigbo
15th April, 2018, 10:05 AM
this is 3plugs but mine is 4plugs
Samsara
15th April, 2018, 10:16 AM
Ok, sorry, check those .
What is you car model?
Where are you pick-up this ECU?
ezenigbo
15th April, 2018, 05:05 PM
i have done the connection with tactrix open port 2.0,when i press ECU INFO,i recognized the ecu but when i press READ,t will not connect but show error,although i did not connect vpp beccause i dont know where to connect it,please what am i doing wrong?
NASTASE
15th April, 2018, 05:16 PM
Piassini master clone tool work perfect on this ECU, tested by me two times.KTAG fail in write.Have pin connection on Piassini docs
ezenigbo
15th April, 2018, 05:29 PM
please can you give me your own pin connection?
Samsara
15th April, 2018, 07:44 PM
please what am i doing wrong?
You do not answer questions and you do not thank for help.
NASTASE
16th April, 2018, 05:35 PM
please can you give me your own pin connection?
Hi mate, here you are Piassini connection for Mitsu,don't need 16V flash voltage, is enough 12V.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.