Manta1600
1st May, 2018, 10:56 PM
Its my own car C3 Picasso 2014 1.6 Petrol Automatic - was 5600 miles on the dash
After water ingress in the ECU - ECU stopped communicating with BSI - 9666952380 X05
Starter can't turn over and shifts don't appear on the dash
I bought Lexia and check showed me U1108 and U0404
I found the same ECU 0261S07906 MEV 17_4_2 but with different BSI 9666952280 X04 from DS 1.6 automatic + key
When I put them - car starts and drives but doesn't work properly - shifts don't appear on the dash and fan works continuously - dash shows 12436 miles
When I use my BSI with new ECU - shifts appear on the dash but car can't start because immo code is different on ECU - dash show 12436 miles that are stored from the new BSI that I connected before
What is better to do now :
- virginase the new ECU and add to my BSI - What tools must I use?
or
- Try to read my old ECU and rewrite on the new ECU - What tool must I use?
also I want to back mileage again to 5600 on the dash - can I do this over OBD or must I open the dash - what tool must I use?
I already bought some tools but never used them - are they suitable for this job or must I buy other
VD300 FGTECH galletto 4 V54
KTAG 7.020 Programmer V2.23
BDM100 PROGRAMMER
FVDI 2014 Abrites
Carprog Full V10.05
Thanks
After water ingress in the ECU - ECU stopped communicating with BSI - 9666952380 X05
Starter can't turn over and shifts don't appear on the dash
I bought Lexia and check showed me U1108 and U0404
I found the same ECU 0261S07906 MEV 17_4_2 but with different BSI 9666952280 X04 from DS 1.6 automatic + key
When I put them - car starts and drives but doesn't work properly - shifts don't appear on the dash and fan works continuously - dash shows 12436 miles
When I use my BSI with new ECU - shifts appear on the dash but car can't start because immo code is different on ECU - dash show 12436 miles that are stored from the new BSI that I connected before
What is better to do now :
- virginase the new ECU and add to my BSI - What tools must I use?
or
- Try to read my old ECU and rewrite on the new ECU - What tool must I use?
also I want to back mileage again to 5600 on the dash - can I do this over OBD or must I open the dash - what tool must I use?
I already bought some tools but never used them - are they suitable for this job or must I buy other
VD300 FGTECH galletto 4 V54
KTAG 7.020 Programmer V2.23
BDM100 PROGRAMMER
FVDI 2014 Abrites
Carprog Full V10.05
Thanks