View Full Version : FGtech galletto V54 error HELP
Shakeelbhugeloo
12th May, 2018, 10:13 PM
Hello am trying to read an EDC16 Ecu mercedes Bosch 0 281 011 072 with mpc555 but not successfull with FGtech galletto can anyone help below attached pictures. Can anyone tell me what am doing wrong ?
Shakeelbhugeloo
12th May, 2018, 10:18 PM
more pictures
Shakeelbhugeloo
12th May, 2018, 10:21 PM
please help
AVDigitale
12th May, 2018, 10:45 PM
check connection in bdm pads,wires
is a clone maybe that is problem you can't read ecu
morgano
13th May, 2018, 12:03 AM
Problem is he don’t read on screen what he’s doing.
He’s trying to JTAG AS MPC55xx and what he should do is BDM MPC5xx processor.
Two different ways to two different families of processors. Just that.
Shakeelbhugeloo
13th May, 2018, 08:26 PM
Can you please explain what error am doing ? am new to this
morgano
13th May, 2018, 08:43 PM
Can you please explain what error am doing ? am new to this
You keep paying no attention to your screen, neither galletto software nor my previous post, i already explained which your error is, read again.
maajkii
13th May, 2018, 10:56 PM
Can you please explain what error am doing ? am new to this
Chose ( When you chose ecu ), BDM And MPC5xx
Not Jtag!!
Wysłane z iPhone za pomocą Tapatalk
Shakeelbhugeloo
14th May, 2018, 05:29 PM
i tried but no succcess
jakesman
14th May, 2018, 07:02 PM
bdm pins making contack like in picture ?also had this problem until i got this pinout , never had problems after i use this
Shakeelbhugeloo
14th May, 2018, 08:09 PM
Do you have the connections using wires ? which colour is which ? and whats about the 12v IGn ?
kospoz
14th May, 2018, 08:36 PM
mate calm down read the manual all are there read first and then try
morgano
14th May, 2018, 11:00 PM
Maybe it is too late for that ecu, and bdm port is fried.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.