bricoautomalaga
21st May, 2018, 12:51 PM
Hello friends.I'm new in the forum.I have a problem with this edc15c2 (three connectors)I programmed an immooff file of ecuvonix, first to the flash and to the eprom and it did not start, after only the eprom and if I start several times (but do not disconnect the inmobox), then I stop booting.
After disconnecting the inmobox, I re-programmed the eprom (95p08), but nothing, I tried several files and nothing.I have mounted a new memory 95080, protected against writing, but neither, gives failure of programming of eprom
.What do you advise me? I'm looking for another new uce?
Does anyone have an immo image file, that works?Greetings and thanks!
After disconnecting the inmobox, I re-programmed the eprom (95p08), but nothing, I tried several files and nothing.I have mounted a new memory 95080, protected against writing, but neither, gives failure of programming of eprom
.What do you advise me? I'm looking for another new uce?
Does anyone have an immo image file, that works?Greetings and thanks!