BMW 1-series ELV I NEED VIRGIN DUMP

[kamonyi]

Hi, I NEED VIRGIN DUMP FOR BMW 1-SERIES ELV STEERING LOCK eeprom 25040
BMW 1- series Ecu was burnt .I got used kit that has ECU ,CAS and body control module.
I installed to the car but not cranking, it shows steering lock error to the dash board.
when I put back its old CAS IT CRANKS WELL .

I need to use old ELV to that newcomer parts ecu ,cas, bcm .
here is my dump

[kamonyi]

any idea for synchronization for this bmw elv

[rola1971]

any idea for synchronization for this bmw elv
all normal programmer make sinhro for evl
avdi
bmw eplorer
vvdi2
fvdi
good luck

[kamonyi]

I did it by avdi fvdi

[kamonyi]

I did it by avdi fvdi

I did it by fvdi bat not accepted I need virgin dump

[kamonyi]

any help please

[brobble]

Normally you dont need virgin file for elv. You can take used elv to another car, erase elv counter and done. But notice, that there are 2 different elv modules in E87. 3pin elv and 4pin elv. I believe cas2 has 3 pin elv and cas3 has 4pin elv. I you changed from cas2 to cas3 for example you need another elv.

Greets MR...

[kamonyi]

Normally you dont need virgin file for elv. You can take used elv to another car, erase elv counter and done. But notice, that there are 2 different elv modules in E87. 3pin elv and 4pin elv. I believe cas2 has 3 pin elv and cas3 has 4pin elv. I you changed from cas2 to cas3 for example you need another elv.

Greets MR...

thank you for opening my ayes my car is my car is cas 3 new ecu kit is cas2 what is to be donne to these wire as mine has 4wires

[brobble]

Cas2 need 3pin elv. Why you canged all this parts? Maybe you still have your original cas3? You wrote, ecu was burnt. Why dont you install original cas3, use original keys and adapt used ecu. It´s not hard to virginze old ecu or only rewrite ISN and adapt it to original cas.

Greets MR...