View Full Version : Problem with edc17c10
sdtsedat
20th June, 2018, 12:56 PM
Hi people,
Today i try read security code with avdi abrites for Citroen Berlingo 1.6hdi edc17c10
But after this procedure i have this message and nothing work in car, no lights, no dash, nothing. I can not read ecu.
I think car is in transportmode. Someone experience with this situation? Who can help?
https://uploads.tapatalk-cdn.com/20180620/3827fe2772ed6fecb7834ff3b02cf704.jpg
Verstuurd vanaf mijn SM-G955F met Tapatalk
quikcar
20th June, 2018, 01:19 PM
if BSI johonson control
bsi is dead you must change it abritus not good with this type of bsi
other thing next time put a charger in battery
good luck
sdtsedat
20th June, 2018, 01:24 PM
But nothing work, like disconnect battery. This is normal if BSI dead?
Verstuurd vanaf mijn SM-G955F met Tapatalk
quikcar
20th June, 2018, 02:08 PM
you must vergin and read PIN from ECU, after that reconfigure BSI (add VIN, keys, check configuration again) with diagbox
i will give you
TUTORIAL: REALIZATION of a cable to read bsi JC on table with fVDI without opens or soldered
safe, no meter that does not light or car HS ext ..
this method will permit:
01: Read the pine code or change the
02: Read the VIN or change
03: know the real KM buy a BSI was the case before connecting on the car:
04: BSI out in a boot after a broken play
I enclose
1: Scheme of the realization of cable PDF
2: the completion of the cable when finished
3: cock out for connection to the bsi and the magnetization 12V and GND
and a reading demonstration video with fVDI (if like you're plugged into a car (secure, fast and safe
see you skype i send you a video
johak
20th June, 2018, 02:09 PM
But nothing work, like disconnect battery. This is normal if BSI dead?
Verstuurd vanaf mijn SM-G955F met Tapatalk
Yes, when you dont have "K15" from BSI
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.