View Full Version : SMOK not write CDC3217G?
madman47
27th June, 2018, 01:42 PM
Is this correct?
why???
What is a good tool to write this MCU??
mobel
27th June, 2018, 02:13 PM
Upa s, xprog, ...
Sent from my iPhone using Tapatalk
madman47
27th June, 2018, 02:23 PM
xprog always gives verify error. no matter what i do always verify error
mobel
27th June, 2018, 02:30 PM
xprog always gives verify error. no matter what i do always verify error
Try to give an external power to xprog. Do you use the correct pinout?
Sent from my iPhone using Tapatalk
madman47
27th June, 2018, 02:36 PM
yes always use external power. Yes correct pinout. Tried with and without xtal connected. Using rev C jtag board
It will pass sec and read mcu, but never verify.
tried on different dash, same
madman47
27th June, 2018, 02:38 PM
SMOK read mcu flash only. this verifies fine, but SMOK not write!!!
so, i have to use other tool to write
madman47
27th June, 2018, 02:42 PM
PS- UPA not support Micronas
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.