PDA

View Full Version : BMW F15 - X5 - 2016 // RED DOT after emulator



CARPARTS
10th July, 2018, 03:43 PM
Hi

Dash has original 35160WT, so i use emulator with 95256 chip (put 35160 chip-ID in line $4000 from the 95256)

In BDC, i used 2 can blockers ;
1 for block communication between BDC and odometer
1 in OBDII for reading same km-values by OBDII

red dot appears in dash !!


close doors 1 hours, drive 32 km........red dot still there
few days later....dash totally dead....remove battery, dash back alive + "red dot" stil there
few days later.... 999999 km in dash + red dot..........


Anyone has same problems with those emulators from elprosys , or has working solution ????


Thanks for info

smartymarti
11th July, 2018, 10:22 AM
Hi

Dash has original 35160WT, so i use emulator with 95256 chip (put 35160 chip-ID in line $4000 from the 95256)

In BDC, i used 2 can blockers ;
1 for block communication between BDC and odometer
1 in OBDII for reading same km-values by OBDII

red dot appears in dash !!


close doors 1 hours, drive 32 km........red dot still there
few days later....dash totally dead....remove battery, dash back alive + "red dot" stil there
few days later.... 999999 km in dash + red dot..........


Anyone has same problems with those emulators from elprosys , or has working solution ????


Thanks for info

used the elprosys one and never had any issues the 999999 will always come on when power is disconnected just re do mileage , as for the 2 blockers in bdc that may be the issue also you will find when you plug in to do diagnostics , the car wont read and you cant erase any fault codes this is down to the 2 blockers in bdc

CARPARTS
11th July, 2018, 01:03 PM
used the elprosys one and never had any issues the 999999 will always come on when power is disconnected just re do mileage , as for the 2 blockers in bdc that may be the issue also you will find when you plug in to do diagnostics , the car wont read and you cant erase any fault codes this is down to the 2 blockers in bdc


indeed, i removed only 1 blocker in the OBDII line, and now i am able to read and erase DTC from each module

but.......red dot still is there


how this "red dot" will disappear ??

smartymarti
12th July, 2018, 07:48 AM
Put original back in and see if it goes , if it does the redo emulated again