PDA

View Full Version : issue finding mapping software to connect to my van



newtothis017
21st July, 2018, 06:07 AM
having problems , having my van mapped , the likes off kess v2 doesnt even list the correct engine model with the correct ecu model . the model of my van is 2006 preface lift astra g van 1.7 cdti z17dtl edc15c7 but the only one kess lists is edc16 , and galletto has speed error

DR Race
21st July, 2018, 06:28 AM
having problems , having my van mapped , the likes off kess v2 doesnt even list the correct engine model with the correct ecu model . the model of my van is 2006 preface lift astra g van 1.7 cdti z17dtl edc15c7 but the only one kess lists is edc16 , and galletto has speed errorThe model in K suite it is sometimes only for orientation, normally kess it will tell you , "wrong protocol please use protocol xxx" if it read correctly then your car is fitted with edc 16 ecu !

Trimis de pe al meu SM-G960F folosind Tapatalk

newtothis017
21st July, 2018, 06:40 AM
kess wont read it atall , think its due to van being so close to the change over facelift , as alot of places take the registration as a astra h but is actually a astra g . and had ecu confirmed of being edc15c7 by op-com thanks for replie

DR Race
21st July, 2018, 07:03 AM
kess wont read it atall , think its due to van being so close to the change over facelift , as alot of places take the registration as a astra h but is actually a astra g . and had ecu confirmed of being edc15c7 by op-com thanks for replieTake ecu out and try to read over direct mode, you only need 4 whires,2 +, -, Kline and resistor , for fg techhttps://uploads.tapatalk-cdn.com/20180721/166f4f9e9de10b4898e1fd3001c72361.jpghttps://uploads.tapatalk-cdn.com/20180721/001724aee7db3772f024c95e3dc22f77.jpg

Trimis de pe al meu SM-G960F folosind Tapatalk